flush your water heater

Why You Need to Flush Your Water Heater

/in , /by

How long will your water heater last? The answer to that question depends on a number of factors, including the quality of the water heater you purchase, but also how well you maintain it. In this blog we will talk about why you need to flush your water heater to keep it working well and extend its life.

What Is the Average Lifespan of a Water Heater? 

The rule of thumb is that a water heater should last about 10 years. Of course, this depends on the amount of work the heater has to do over its lifetime as well as the conditions it operates under. If your house uses a great deal of water for bathing, laundry, or cleaning, that means the water heater has to work harder. Remember, you expect there to be hot water whenever you turn on your tap. In order for that to happen, your water heater is working even when you’re not thinking about it. Your refrigerator is probably the only other appliance you have that operates continuously. 

The hardness of your water also contributes to how much your water heater has to work. Hard water has a higher mineral content. This mineral content builds up on the inside of your water heater and on its heating element slowly over time and reduces its efficiency. Excessive sediment buildup at the bottom of a gas water heater can create hot spots and damage the tank. If you hear popping or rumbling noises coming from your water heater, you have a problem with sediment buildup, and you need to have it addressed.

What is the solution? You need to flush your water heater. 

Why You Need to Flush Your Water Heater

no hot waterLike most of your home appliances, your hot water heater does need periodic maintenance. It may keep chugging along seemingly without problems, but that doesn’t mean it’s operating at full capacity or efficiency. Over time it will use more energy to heat the water, and it may fail completely and require replacing if you don’t flush it out. 

Flushing your water heater will remove the lime buildup on the lower heating element in electric water heaters and prevent uneven heating at the bottom of the gas water heaters that can lead to leakage. For both types of water heaters, flushing will remove the sediment that can cause the drain valve to clog. 

Ideally, most water heaters should be flushed every six months to prevent damage. If your water is very hard, you may want to do it more often. Draining and flushing the tank is an involved chore, so many homeowners will call a licensed plumber to service it annually. A plumber will inspect the tank for rust and leaks as well as test the thermostat and valves. He will replace the anode rod to prevent corrosion too. 

If you don’t know how to drain the tank without creating a watery mess or want to fuss with your pilot light, calling a plumber to inspect and flush your water heater is the way to go. Over time, this maintenance will produce lower heating bills and a longer lasting water heater. 

If you have concerns about your water heater or would like to schedule maintenance, contact Weinkauf Plumbing & Heating. We want to keep your plumbing in tip top condition so you do not have to worry about outages or leaks. Call us – we’re here to help!

 

plumbing emergency

What Is a Plumbing Emergency?

/in , /by

Working plumbing is such a necessary part of modern life that any plumbing problem can seem like a plumbing emergency. Some problems are less urgent than others, however. In this blog we’ll list issues that are truly emergencies. This way you will be able to tell the difference between what is an unhappy inconvenience and what will cause you more problems if it doesn’t get fixed immediately. 

What Is a Plumbing Emergency?

A Burst Pipe

Water can cause a great deal of damage in a short period of time. The more water, the more damage it can cause. A burst pipe can release many gallons of water in a few minutes. If you have a pipe break, it’s an emergency, and you should call your plumber immediately. Find the stop valve for the water at the break and use it if possible. If you cannot isolate the leak, turn the water off at the main water supply. Then mop up any water you can and dry out any carpeting. Mold and mildew will result if you do not properly remove all water, and that’s a health hazard. 

An Overflowing Toilet 

Any clogged pipe or drain paired with running water can result in the same kind of damage that a burst pipe does – except the water will not be clean. You should shut off the water at the valve (located near the back or base of the toilet) to stop the water flow and attempt to plunge the toilet. If you cannot get the blockage cleared and this is a necessary toilet or the only toilet in the house, that’s a plumbing emergency. 

A Broken Water Heater

Hot water is necessary for cleaning and washing, so if your hot water heater breaks, it causes real inconvenience, especially in the colder winter months. A noisy hot water heater can also signal that there’s something seriously wrong. If you have a leak in the main tank, it can cause water damage to your home. Depending on the urgency of any of the above situations, it may be time to call out the emergency plumber to drain, repair, or replace your water heater. 

Frozen Pipes

In February of 2021, many southern states and much of the state of Texas experienced a sharp freeze that ultimately resulted in a cost of 18 billion dollars in home damages. The average insurance claim for frozen pipes is more than $25,000, in fact. This is because it involves burst pipes in multiple locations and often the water runs for some time before it’s noticed and addressed. In that time it can cause damage to ceilings, floors, walls, and wiring, all of which are expensive to repair or replace. If you think your pipes have frozen, you will need to turn off the water at the main water supply and call your plumber. 

A Sewer Backup 

The water you use that you flush or drain exits your house via your sewer/wastewater line and from there goes into the municipal sewer system. A sewer backup means that that water or waste cannot leave or comes back up from the clogged line into your home. When this happens, it’s not good. The most common sewer backup situation involves pipes that are clogged with toilet paper, wet wipes, sanitary napkins, hair, or grease. 

If you notice that you have noises or bad smells coming from multiple sources, you may have a sewage issue. You will need to call your plumber immediately before it gets worse and causes damage or creates a biohazard.  

Should You Call an Emergency Plumber?

If you are not sure if you have a plumbing emergency, you can always call and discuss your situation with your plumbing company. In some cases, if it’s only a matter of inconvenience, you may be able to wait and avoid calling in a plumber after normal business hours, reducing your costs. As a rule of thumb, if you have to shut off the water at the main supply, it’s an emergency. Also, if you feel there is something wrong with your water supply, if it looks or smells funny, you should immediately contact a plumber as well. 

At Weinkauf Plumbing & Heating, we have a 24-hour emergency line for service. If you are in the Alpena area and have an urgent plumbing problem, call us. We will diagnose the problem and get your plumbing back in working order for you right away. 

 

 

no hot water

No Hot Water? It Could Be Time for a New Water Heater

/in , /by

It’s never a good time for your hot water supply to fail. If you’ve tried to turn on the hot water in your shower or at your kitchen faucet and gotten only cold, that’s frustrating. You need that water for cleaning, bathing, and doing laundry. In the wintertime, a hot bath or shower can be especially relaxing and comforting. What is the underlying cause of your hot water failure? It could be one of a number of things. We will go through the possibilities in this blog. 

Why Is There No Hot Water? 

A water heater has a number of inputs, electricity, gas, and water, and also mechanical aspects. If something goes wrong with any one of these, your hot water output will be impacted. 

If you have a smaller water heater, you may find that it cannot keep up with your household use, so you’ll run out of hot water frequently. It may also cost more to run because of lower energy efficiency. This is the simplest hot water problem to have because you can either decide you’d like to install a larger hot water heater to better meet your needs, or you can wait for it to heat up more water. Ask your plumber if you’re not sure which size or model of hot water heater would best suit your use pattern. 

Another potentially simple-to-fix malfunction is an electrical issue like a tripped breaker or a high-temperature cut-off switch on your water heater. To determine if it’s a breaker problem, turn off your water heater and then check your circuit breaker to see if a breaker has tripped. You can then turn it off and then on again. If that does not solve the problem or your breaker trips again, you will need to call an electrician for assistance. 

Gas Problems

If your water heater is gas powered, there are several potential problems that involve gas. One of them is a gas leak. If you smell gas in your home for any reason, you need to contact your gas company immediately. Gas leaks are dangerous, especially during the winter when your house is closed up and there is no way for gas to escape outside. 

You may have a leaky supply line or a failing gas valve. If your water heater runs on gas, it will have a pilot light and a burner located at the bottom of the heater behind an access panel. Check that your pilot light is on. If it’s not on, relight it. If it goes out again, you have a problem with your gas line, and you will need to involve a trained technician to examine your heater and determine what is wrong. 

A Malfunctioning Water Heater

There are a number of ways the water heater itself could fail. You may notice that the water temperature swings or is inconsistent. It heats but unpredictably. It could have a bad thermostat, a failing or broken heating element, or sediment buildup. 

The tank could also have a leak. If the water leaks out of the unit, it won’t heat, of course, but it will also make a mess. You may not be able to determine the source of the leak yourself. If your water heater is leaking, turn off the water to your tank, and call your plumber. An experienced technician will be able to inspect the tank, the pipes, connections, and valves, diagnose the problem, and let you know your options for repair or replacement. 

If you are in the Alpena or Oscoda, Michigan areas and experience the problem of no hot water when you turn on your faucet, call us at Weinkauf Plumbing and Heating. Our trained technicians will be able to diagnose your problem quickly and find a solution to get your hot water running again. Contact us at (989) 354-5427 for help. We’re here to make sure you can be safe, warm, and comfortable in your home this winter.